Table of Contents
Advertisement
The following table describes how to configure your TCP/IP filter rule.
FIELD
Filter #
Filter Type
Active
IP Protocol
IP Source Route
Filter Configuration
Menu 21.1.1 - TCP/IP Filter Rule
Filter #: 1,1
Filter Type= TCP/IP Filter Rule
Active= Yes
IP Protocol= 6
Destination: IP Addr= 0.0.0.0
Source: IP Addr= 0.0.0.0
TCP Estab= No
More= No
Action Matched= Check Next Rule
Action Not Matched= Check Next Rule
Press ENTER to Confirm or ESC to Cancel:
Figure 8-10 Menu 21.1.1 – TCP/IP Filter Rule
Table 8-3 TCP/IP Filter Rule Menu Fields
DESCRIPTION
This is the filter set, filter rule coordinates, for instance, 2,
3 refers to the second filter set and the third filter rule of
that set.
Use [SPACE BAR] and then [ENTER] to choose a rule.
Parameters displayed for each type will be different.
Choices are TCP/IP Filter Rule or Generic Filter Rule.
Select Yes to activate or No to deactivate the filter rule.
This is the upper layer protocol, for example, TCP is 6,
UDP is 17 and ICMP is 1. The value must be between 0
and 255. A value of O matches ANY protocol.
IP Source Route is an optional header that dictates the
route an IP packet takes from its source to its destination.
If Yes, the rule applies to any packet with an IP source
route. The majority of IP packets do not have source
route.
IP Source Route= No
IP Mask= 0.0.0.0
Port #= 137
Port # Comp= Equal
IP Mask= 0.0.0.0
Port #= 0
Port # Comp= None
Log= None
Prestige 650R-31/33 ADSL Router
EXAMPLE
TCP/IP Filter Rule
1,1
No
0 to 255
No
8-9
Advertisement
Table of Contents
Troubleshooting
