Step 2.
From menu 12, enter 1 to open Menu 12.1 – IP Static Route Setup (shown next).
Step 3.
Type the route number of a static route you want to configure and then press [ENTER].
The following table describes the fields for Menu 12.1.1 – Edit IP Static Route Setup.
FIELD
Route #
Route Name
Active
Destination IP Address
Remote Node TCP/IP Configuration
Menu 12.1 - IP Static Route Setup
1. ________
2. ________
3. ________
4. ________
5. ________
6. ________
7. ________
8. ________
Enter selection number:
Figure 5-7 Menu 12.1 – IP Static Route Setup
Menu 12.1.1 - Edit IP Static Route
Route #: 1
Route Name= ?
Active= No
Destination IP Address= ?
IP Subnet Mask= ?
Gateway IP Address= ?
Metric= 2
Private= No
Press ENTER to Confirm or ESC to Cancel:
Figure 5-8 Edit IP Static Route
Table 5-3 Edit IP Static Route Menu Fields
This is the index number of the static route that you chose in menu 12.1.
Type a descriptive name for this route. This is for identification purpose only.
This field allows you to activate/deactivate this static route.
This parameter specifies the IP network address of the final destination.
Routing is always based on network number. If you need to specify a route to
a single host, use a subnet mask of 255.255.255.255 in the subnet mask field
to force the network number to be identical to the host ID.
Prestige 650R-31/33 ADSL Router
DESCRIPTION
5-7