Applying An Ip Policy; Ethernet Ip Policies - ZyXEL Communications Prestige 650R-31/33 User Manual

FIELD
Source:
addr start / end
port start / end
Destination:
addr start / end
port start / end
Action
Gateway addr
Type of Service
Precedence
Log
When you have completed this menu, press [ENTER] at the prompt "Press ENTER to confirm or ESC to
cancel" to save your configuration or press [ESC] to cancel and go back to the previous screen.

13.5 Applying an IP Policy

This section shows you where to apply the IP policies after you design them.

13.5.1 Ethernet IP Policies

From Menu 3 – Ethernet Setup, type 2 to go to Menu 3.2 – TCP/IP and DHCP Ethernet Setup.
You can choose up to four IP policy sets (from 12) by typing their numbers separated by commas, for
example, 2, 4, 7, 9.
IP Policy Routing
Table 13-2 IP Routing Policy
Source IP address range from start to end.
Source port number range from start to end; applicable only for TCP/UDP.
Destination IP address range from start to end.
Destination port number range from start to end; applicable only for TCP/UDP.
Specifies whether action should be taken on criteria Matched or Not
Matched.
Defines the outgoing gateway address. The gateway must be on the same
subnet as the Prestige if it is on the LAN, otherwise, the gateway must be the
IP address of a remote node. The default gateway is specified as 0.0.0.0.
Set the new TOS value of the outgoing packet. Prioritize incoming network
traffic by choosing No Change, Normal, Min Delay, Max Thruput, Max
Reliable or Min Cost.
Set the new outgoing packet precedence value. Values are 0 to 7 or No
Change.
Press [SPACE BAR] and then [ENTER] to select Yes to make an entry in the
system log when a policy is executed.
Prestige 650R-31/33 ADSL Router
DESCRIPTION
13-5