Table of Contents
Advertisement
Remote Node Configuration
A remote node is required for placing calls to a remote gateway. A remote node
represents both the remote gateway and the network behind it across a WAN
connection. Note that when you use Menu 4 to set up Internet access, you are
actually configuring one of the remote nodes. Once a remote node is configured
correctly, traffic to the remote network will trigger your Prestige to make a call
automatically, i.e., Dial On Demand.
In this chapter, we will discuss the parameters that are protocol independent. The
protocol-dependent configuration will be covered in subsequent chapters. For
TCP/IP, see Chapter 5, for IPX, see Chapter 6 and for Bridging, see Chapter
7.
4.1
Remote Node Setup
This section describes the protocol-independent parameters for a remote node.
4.1.1 Remote Node Profile
To configure a remote node, follow these steps:
From the Main Menu, select menu option 1. Remote Node Setup
Step 1.
When Menu 11 appears, as shown below, enter the number of the
Step 2.
remote node that you wish to configure.
Remote Node Configuration
Prestige 128+ ISDN Router
Chapter 4
4-1
Advertisement
Table of Contents
Troubleshooting
