Table of Contents
Advertisement
A remote node is required for placing calls to a remote gateway. A remote node represents both the remote
gateway and the network behind it across an IDSL connection. Note that when you use Menu 4 to set up
Internet access, you are actually configuring a remote node.
Even though you can configure up to four remote nodes, the first active remote node is used to connect to
the remote LAN. It is good practice to keep only one active remote node for your Prestige.
In this chapter, we discuss the parameters that are protocol independent. The protocol dependent
configuration is covered in subsequent chapters. You are also shown how to configure Menu 11.1 Remote
Node Profile, Menu 11.2 – Remote Node PPP Options, Menu 11.3 – Remote Node Network Layer
Options and Menu 11.5 – Remote Node Filter.
4.1
Remote Node Profile
From the Main Menu, select menu option 11 to open Menu 11.1 – Remote Node Profile.
Remote Node Setup
This chapter shows you how to configure a remote node.
Menu 11.1 - Remote Node Profile
Rem Node Name=
Active =Yes
Incoming:
Rem Login=
Rem Password=
Outgoing:
My Login=
My Password=
Authen= CHAP/PAP
Press ENTER to Confirm or ESC to Cancel:
Figure 4-1
Menu 11.1 – Remote Node Profile
Remote Node Setup
Edit PPP Options= No
Rem IP Addr= 0.0.0.0
Edit IP= No
Session Options:
Edit Filter Sets= No
Prestige 100L IDSL Router
Chapter 4
4-1
Advertisement
Table of Contents
Troubleshooting
