Initial Screen; Entering Password; Resetting The Prestige; Figure 2-6 Power-On Display - ZyXEL Communications Prestige 650R-31/33 User Manual

Zyxel adsl router user's guide

Table of Contents

Prestige 650R-31/33 ADSL Router

2.7.1 Initial Screen

When you turn on your Prestige, it performs several internal tests as well as line initialization. After the

initialization, the Prestige asks you to press [ENTER] to continue, as shown.

initialize ch = 0, ethernet address: 00:a0:c5:32:9b:dc

Wan Channel init ........ done

Loading ADSL modem F/W

................................................................. done

Press ENTER to continue...

The login screen appears after you press [ENTER], prompting you to enter the password, as shown next.

For your first login, enter the default password "1234". As you type the password, the screen displays an

"X" for each character you type.

Please note that if there is no activity for longer than five minutes after you log in, your Prestige will

automatically log you out and will display a blank screen. If you see a blank screen, press [ENTER] to

display the login screen again.

2.8

If you forget your password or cannot access the Prestige, you will need to reload the factory-default

configuration file. Uploading this configuration file replaces the current configuration file with the factory-

default configuration file. This means that you will lose all configurations that you had previously and the

speed of the console port will be reset to the default of 9600bps with 8 data bit, no parity, one stop bit and

flow control set to none. The password will be reset to "1234" and the LAN IP address to 192.168.1.1.

To obtain the default configuration file, download it from the ZyXEL FTP site, unzip it and save it in a

folder. Turn the Prestige off and then on to begin a session. When you turn on the Prestige again you will

2-8

Enter Password : XXXX

Hardware Installation and Initial Setup

Table of Contents

Prestige 650r-31 Prestige 650r-33