Tcp/Ip Configuration; Editing Tcp/Ip Options; Figure 5-1 Menu 11.6 For Vc-Based Multiplexing; Chapter 5 Remote Node Tcp/Ip Configuration - ZyXEL Communications Prestige 650R-31/33 User Manual

Remote Node TCP/IP Configuration
This chapter shows a sample LAN-to-LAN application and how to configure TCP/IP remote node.
5.1

TCP/IP Configuration

The following sections describe how to configure the TCP/IP parameters of a remote node.

5.1.1 Editing TCP/IP Options

Follow the steps shown next to edit Menu 11.6 – Remote Node ATM Layer Options.
In menu 11.1, move the cursor to the Edit ATM Options field and then press [SPACE BAR] to select
Yes. Press [ENTER] to display Menu 11.6 – Remote Node ATM Layer Options.
There are two versions of menu 11.6 for the Prestige, depending on whether you chose VC-based/LLC-
based multiplexing and PPPoA encapsulation in menu 11.1.
VC-based Multiplexing
For VC-based multiplexing, by prior agreement, a protocol is assigned a specific virtual circuit, for
example, VC1 will carry IP. Separate VPI and VCI numbers must be specified for each protocol.
VC Options for IP:
VPI #= 8
VCI #= 35
ATM QoS Type= UBR
Peak Cell Rate (PCR)= 0
Sustain Cell Rate (SCR)= 0
Maximum Burst Size (MBS)= 0
Remote Node TCP/IP Configuration
VPI/VCI (VC-Multiplexing)
Enter here to CONFIRM or ESC to CANCEL:

Figure 5-1 Menu 11.6 for VC-based Multiplexing

VC Options for Bridge:
VPI #= N/A
VCI #= N/A
ATM QoS Type= N/A
Peak Cell Rate (PCR)= N/A
Sustain Cell Rate (SCR)= N/A
Maximum Burst Size (MBS)= N/A
Prestige 650R-31/33 ADSL Router
Chapter 5
Separate VPI and
VCI numbers must be
specified for each
protocol.
5-1