ZyXEL Communications Prestige 650R-31/33 User Manual page 70

Prestige 650R-31/33 ADSL Router
FIELD
Encapsulation
Multiplexing
Service Name
Incoming:
Rem Login
Rem Password
Outgoing:
My Login
My Password
Authen
Route
Bridge
Edit IP/Bridge
4-4
PPPoE (Point-to-Point Protocol over Ethernet).
PPPoA refers to RFC-2364 (PPP Encapsulation over ATM
Adaptation Layer 5).
If RFC-1483 (Multiprotocol Encapsulation over ATM Adaptation
Layer 5) or ENET ENCAP are selected,
then the Rem Login, Rem Password, My Login and My
Password Options and Authen fields are not applicable (N/A).
Press [SPACE BAR] and then [ENTER] to select the method of
multiplexing that your ISP uses, either VC-based or LLC-based.
When using PPPoE encapsulation, type the name of your PPPoE
service here.
Type the login name that this remote node will use to call your
Prestige. The login name and the Rem Password will be used to
authenticate this node.
Type the password used when this remote node calls your
Prestige.
Type the login name assigned by your ISP when the Prestige
calls this remote node.
Type the password assigned by your ISP when the Prestige calls
this remote node.
This field sets the authentication protocol used for outgoing calls.
Options for this field are:
CHAP/PAP – Your Prestige will accept either CHAP or PAP when
requested by this remote node.
CHAP – accept CHAP (Challenge Handshake Authentication
Protocol) only.
PAP – accept PAP (Password Authentication Protocol) only.
This field determines the protocol used in routing. Options are IP
and None.
When bridging is enabled, your Prestige will forward any packet
that it does not route to this remote node; otherwise, the packets
are discarded. Select Yes to enable and No to disable.
Press [SPACE BAR] to select Yes and press [ENTER] to display
Menu 11.3 – Remote Node Network Layer Options.
DESCRIPTION EXAMPLE
ENET ENCAP
LLC-based
CHAP/PAP
IP
No
No
Remote Node Configuration