Step 1.
Enter 11 from the main menu.
Step 2.
Move the cursor to the Edit IP field, press [SPACE BAR] to select Yes and then press
[ENTER] to bring up Menu 11.3 - Remote Node Network Layer Options.
IP Options:
IP Address Assignment= Static
Rem IP Addr: 0.0.0.0
Rem Subnet Mask= 0.0.0.0
My WAN Addr= 0.0.0.0
NAT= Full Feature
Address Mapping Set= 2
Metric= 2
Private= No
RIP Direction= Both
Version= RIP-2B
Multicast= IGMP-v2
IP Policies=
Figure 7-4 Menu 11.3 – Applying NAT to the Remote Node
The following table describes the options for Network Address Translation.
FIELD
NAT
Press [SPACE BAR] and then [ENTER] to select Full Feature if you
have multiple public WAN IP addresses for your Prestige. The SMT
uses the address mapping set that you configure and enter in the
Address Mapping Set field (menu 15.1 - see section 7.3.1).
Select None to disable NAT.
When you select SUA Only, the SMT uses Address Mapping Set 255
(menu 15.1 - see section 7.3.1). Choose SUA Only if you have just
one public WAN IP address for your Prestige.
7.3
NAT Setup
Use the Address Mapping Sets menus and submenus to create the mapping table used to assign global
addresses to computers on the LAN. You can see two NAT Address Mapping sets in menu 15.1. You can
NAT
Menu 11.3 - Remote Node Network Layer Options
Press ENTER to Confirm or ESC to Cancel:
Table 7-3 Applying NAT in Menus 4 & 11.3
DESCRIPTION
Prestige 650R-31/33 ADSL Router
Bridge Options:
Ethernet Addr Timeout (min)= 0
EXAMPLE
Full Feature
7-7