Configuring Your Wireless Connection - Arris Touchstone TG862G User Manual

2. Insert the plug from the power cord into the Power connector on the back of the
Telephony Gateway (7) and insert the power cord into a convenient AC outlet.
The Power light on the front of the Telephony Gateway lights up, then flashes once. See
the LED tables shown in
Troubleshooting
3. Connect one end of the Ethernet cable to any Ethernet port on the back of the Telephony
Gateway, (5) and the other end to the Ethernet port on a computer, hub, or broadband
router.
Note: If you are connecting to a computer, use the Ethernet cable included in the
Telephony Gateway package.
4. Connect one end of the telephone cable to the telephone port on the back of the
Telephony Gateway (2 or 3). Connect the other end to the telephone.

Configuring Your Wireless Connection

The TG862G ships with a basic factory default configuration that should allow you to
immediately access the Internet with a wireless connection. If your computer is equipped with
an 802.11b/g/n wireless LAN card, you may wish to configure the TG862G's wireless settings.
At a minimum, you should configure the security settings.
Note: Refer to the separate wireless configuration documentation for complete instructions
on configuring your wireless connection.
Release 8 STANDARD 1.1 August 2016
© 2016 ARRIS Enterprises LLC. All Rights Reserved.
Chapter 4: Installing and Connecting your Telephony Gateway
Using the Telephony Gateway
(page 35) if the Power light does not turn on.
(page 29) for more information. See
Touchstone TG862G Telephony Gateway User Guide
25