Table of Contents
Advertisement
The Power light on the front of the Telephony Gateway lights up, then flashes once (refer
to the LED tables shown in
(page 45) if the Power light does not turn on.
3. Connect one end of the Ethernet cable to any Ethernet port on the back of the Telephony
Gateway, (5) and the other end to the Ethernet port on a computer, hub, or broadband
router.
Note: If you are connecting to a computer, use the Ethernet cable included in the
Telephony Gateway package.
4. Connect one end of the telephone cable to the telephone port on the back of the
Telephony Gateway (2 or 3). Connect the other end to the telephone.
Configuring Your Wireless Connection
The TG1662G ships with wireless LAN security set by default. See the security label on your
product for the factory security settings: network name (SSID), encryption method, network
key, and WPS PIN.
Note: You must set up your computer and other client devices to work with the security
settings on the TG1662G. Refer to the documentation for your client device for instructions on
setting security. On most computer systems you only need to select the network name (SSID)
device and enter the encryption key. If your computer or client device supports Wi-Fi Alliance
WPS (Wireless Protected Setup), activate WPS on your computer or client device and the
TG1662G simultaneously to easily set up your system security.
If you need to modify the Telephony Gateway's default wireless security settings, or if you
want to configure any other wireless LAN settings, refer to the following instructions.
Accessing the Configuration Interface
Follow these steps to access the configuration interface. You should have already set up the
TG1662G as described in
1. If security has been properly set up on your computer to access the wireless LAN on the
TG1662G, use the connection utility for your operating system to connect to the wireless
LAN using its network name (SSID), as shown on the security label.
2. If you cannot access the wireless LAN, you must first establish a wired Ethernet connection
between your computer and the TG1662G.
3. In your web browser, open the page http://192.168.0.1/ to access the wireless router
setup.
The Login screen displays.
Note: The default user name is "admin". The default password is "password", in lower
case letters.
Release 16 STANDARD 1.1 August 2016
© 2013-2016 ARRIS Enterprises LLC. All Rights Reserved.
Chapter 5: Installing and Connecting your Telephony Gateway
Using the Telephony Gateway
Installing and Connecting your Telephony Gateway
(page 38)). See
Touchstone TG1662G Telephony Gateway User Guide
Troubleshooting
(page 23).
31
Advertisement
Table of Contents
