Configuring Your Wireless Connection - Arris Touchstone DG3260 User Manual

1. Connect one end of the coax cable to the cable outlet or splitter, and the other end to
the Data Gateway's Cable connector (3). Tighten the connections by hand, then tighten
an additional 1/8 turn with a wrench.
Note: For best performance, use high-quality coax cable and minimize or eliminate splitters
between the cable jack and the Data Gateway.
2. Insert the plug from the power cord into the Power connector on the back of the Data
Gateway (4) and insert the power cord into a convenient AC outlet.
The Power light on the front of the Data Gateway lights up, then flashes once (refer to the LED
tables shown in Using the Data Gateway). See
not turn on.
3. Connect one end of the Ethernet cable to any Ethernet port on the back of the Data
Gateway, (2) and the other end to the Ethernet port on a computer, hub, or broadband
router.
Note: If you are connecting to a computer, use the Ethernet cable included in the Data Gateway
package.

Configuring Your Wireless Connection

The DG3260 ships with wireless LAN security set by default. See the security label on your
product for the factory security settings.
Release 32 STANDARD 1.0 March 2015
Copyright ARRIS Enterprises, Inc. 2015. All Rights Reserved.
Chapter 4: Installing and Connecting your Data Gateway
Troubleshooting (page 34) if the Power light does
Touchstone DG3260 Data Gateway User Guide 21