Table of Contents
Advertisement
Safety & Certifications
HAZARDOUS LOCATIONS
Every HPC50 Series calibrator includes the following Intrinsic Safety approvals:
Ex ia IIC T4/T3 Ga
FTZU 18 ATEX 0043X
ATEX
Ex ia IIC T4/T3 Ga
IECEx FTZU 18.0012X
Entity Parameters
mA/V port
APMi/ATMi ports
Ui = 28 V
Uo = 4 . 9 5 V
li = 94 mA
lo = 731 mA
Pi = 654 mW
Po = 880 mW
Ci = 3 nF
Ci = 83 . 5 µF
Li = 0
Li = 32 . 2 µH
Co = 9 . 2 µF
Lo = 12 µH
!
WARNINGS: The following warnings apply to the HPC50 Series:
•
Do not use the USB connector in hazardous locations.
•
Replace batteries in non-hazardous locations and with approved types only.
•
Do not mix battery types or manufacturers.
•
T4 or T3 Temperature Class is based on selection of approved battery. See
•
Special conditions for safe use:
The equipment shall not be installed in a location where external conditions are conducive to the buildup of electrostatic charge.
CERTIFICATIONS
The HPC50 Series has been tested and certified to comply with a variety of international standards.
This HPC50 complies with the Australian Radiocommunications (Electromagnetic Compatibility) Standard 2008.
Crystal Engineering declares that the HPC50 is in accordance with the ATEX Directive, the Electromagnetic Com-
patibility Directive, and the Pressure Equipment Directive per our declaration(s).
Exia Intrinsically Safe and Non-Incendive for Hazardous Locations:
Class I, Division 1, Groups A, B, C, and D; Temperature Code T4/T3. Class I, Zone 0, AEx ia IIC T4/T3 Ga.
Sécurité intrinsèque et non incendiaire pour dangereux Lieux:
Classe I, Division 1, Groupes A, B, C, and D; Code de température T4/T3. Classe I, Zone 0, AEx ia IIC T4/T3 Ga.
Approved Batteries.
This HPC50 is approved for use as a portable test instrument for Marine
use and complies with DNV GL Rules for Classification of Ships, High
Speed & Light Craft, and Offshore Units.
HPC50 Series Operation Manual
Safety & Certifications
29
Advertisement
Table of Contents
