Setting Modulation; Setting Attenuation - Uniden BCD396T Owner's Manual

To enter additional frequencies, press
scroll control to select New Frequency, then repeat
the above.
Note: If you select Control Channel Only mode (see
"Setting Control-Channel Only (Motorola Systems
Only)" on Page 78), you only need to enter the
frequency(s) that can be assigned as the control
channel. Most frequency lists usually indicate which of
the frequencies are the control channel frequencies.
Otherwise, you must enter all of the frequencies.

Setting Modulation

Program System
Menu
Select the system
Set Modulation
Auto - the scanner uses the default modulation for
the frequency band.
FM - the scanner uses FM (frequency modulation) for
the frequency band.
NFM - the scanner uses narrowband FM for the
frequency band.
Note: The default setting is Auto.
This setting controls the modulation method used for
the frequency band. In most cases, if you leave this
set to Auto, the scanner automatically selects the
correct modulation type for the system you are
programming.

Setting Attenuation

Program System
Menu
Select the system
Set Attenuator
64
Programming Radio Systems
, use the
Menu