Connecting A Smart Ops Pc Module - SMART Board 6000S Pro Series User Manual

Chapter 4
Connecting computers and other devices

Connecting a SMART OPS PC module

If your organization has purchased a SMART OPS PC module, you or your
organization's installers can install the OPS PC module in the display's accessory
slot following the OPS PC module's installation instructions
(smarttech.com/kb/171544). You can then view the OPS PC module's input on
the display.
For more information about the PCM8 series of SMART OPS PC modules, see
SMART OPS PC module on page 15.
CAUTION
Do not install the OPS PC module or remove it from the accessory slot while the display is turned on.
Ensure the power switch on the back of the display beside the AC power inlet is in the OFF (O) position.
TIP
You can install the SMART software that is included with the display on the OPS PC. For more information
on installing software, see Installing and using SMART software on page 33.
Viewing the OPS PC module input
To view the OPS PC module input
1. Do one of the following:
If iQ is enabled
Tap the Home button
and then tap Input
OR
Press the Input button
A screen appears, showing thumbnails of the inputs connected to the display, including the OPS PC
module.
TIP
If iQ is disabled and you want the OPS PC module's input to appear whenever you wake up the
display, tap the star in the upper-left corner of the OPS PC module's thumbnail.
2. Tap the OPS PC module input.
smarttech.com/kb/171415
below the screen,
.
on the remote control.
If iQ is disabled
Tap the Home button
OR
Press the Home button
on the remote control.
below the screen.
or the Input button
38