Connecting A Smart Ops Pc Module - SMART Board MX Series User Manual

Chapter 4 Connecting computers and other devices
The following table presents the recommend resolutions and refresh rates for the display's VGA input
source:
Resolution
1920 × 1080
1600 × 1200
1360 × 768
1280 × 1024
1024 × 768
800 × 600
640 × 480
If possible, set any connected computers to these resolutions and refresh rates. See the connected
computers' operating system documentation for instructions.
Connecting USB drives, peripherals, and other devices
You can use USB drives, peripherals, and other devices with a computer connected to the display using
the USB receptacles on the display.
For more information, see Connecting USB drives, peripherals, and other devices on the next page.
Troubleshooting connected computers
For troubleshooting information for connected computers, see Chapter 5 Troubleshooting on page 40.

Connecting a SMART OPS PC module

If your organization has purchased a SMART OPS PC module, you or your
organization's installers can install the OPS PC module in the display's
accessory slot following the OPS PC module's installation instructions
(smarttech.com/kb/171544). You can then view the OPS PC module's input on
the display.
smarttech.com/kb/171554
Input source Mode
aspect ratio
16:9 [N/A]
4:3 [N/A]
16:9 [N/A]
5:4 SXGA 60
4:3 XGA 60
XGA 70
XGA 75
4:3 SVGA 60
SVGA 72
SVGA 75
4:3 VGA 60
Refresh rate
60.000 Hz
60.000 Hz
60.015 Hz
60.020 Hz
60.004 Hz
70.069 Hz
75.029 Hz
60.317 Hz
72.188 Hz
75.000 Hz
59.940 Hz
37