Working With Images; Saving An Image; Image Capacity; Naming Convention - FLIR Exx Series User Manual

13

Working with images

13.1 Saving an image

13.1.1 Image capacity

This table gives information on the approximate number of infrared (IR) and digital cam-
era (DC) images that can be saved on memory cards:
IR only
Card size
1 GB 5500
2 GB 11 000

13.1.2 Naming convention

The naming convention for images is FLIRxxxx.jpg, where xxxx is a unique counter.

13.1.3 Procedure

Follow this procedure:
1. To save an image, push the Save button.

13.2 Opening a saved image

13.2.1 General

When you save an image, the image is stored on a memory card. To display the image
again, open it from the memory card.
13.2.2 Procedure
Follow this procedure:
1. Push to open the image archive.
2. Push the navigation pad up/down or left/right to select the image you want to view.
3. Push the navigation pad to open the image.
4. Do one of the following:
• Push the navigation pad to edit the image.
• Push to leave the image archive.

13.3 Adjusting an infrared image

13.3.1 General
An infrared image can be adjusted automatically or manually.

13.3.2 Example 1

This figure shows two infrared images of cable connection points. In the left image, a cor-
rect analysis of the circled cable is difficult if you only auto-adjust the image. You can an-
alyze this cable in more detail if you:
• Change the temperature scale level.
• Change the temperature scale span.
In the left image, the image is auto-adjusted. In the right image, the maximum and mini-
mum temperature levels have been changed to temperature levels near the object. On
the temperature scale to the right of each image you can see how the temperature levels
were changed.
#T559845; r.15722/15722; en-US
IR + DC + 30 seconds
IR + DC voice annotation
850 600
1700 1200
26