Table of Contents
Advertisement
1. Oil filler
2. Outlet nozzle
3. Gas-ballast control
4. Gas-ballast inlet
5. Centring-ring and O-ring (supplied)
6. Inlet-port (adaptor flange)
7. Cable-gland/Amphenol connector position
Notes:
1. A pump with a single-phase motor is shown in this figure.
2. The motor shown in this figure is not representative of the motor used on the E2M28 (Amphenol) pump
with Item Number A373-17-984. On this pump, items 7 and 9 are transposed, with Item 7 being an
IEC60320 16-20 Amp socket.
© Edwards Limited 2012. All rights reserved.
Edwards and the Edwards logo are trademarks of Edwards Limited.
Figure 1 - The E2M28/E2M30 pump
8. Motor terminal box
9. On/Off switch
10. Box section skids
11. Oil drain-plug (gravity drain)
12. Oil sight-glass
13. Pump identification label
14. Oil drip tray
A373-10-880 Issue R
Page 3
Advertisement
Table of Contents
