Self Adaption - Lauda PROLINE Kryomats RP 4050 C Operation Manual

Editing the control parameter sets
The change in the control parameters is explained in Section 7.11.1 / 7.11.2 (internal / external). Once the value has
been changed and confirmed, the set number, e.g.
control parameter set to be changed (Set 3) via the command
Control parameter sets

7.11.4 Self Adaption

The function Self Adaption can be used to detect automatically the optimal control parameters for internal or
external control.
The Self Adaption can only be performed on a device with active cooling.
This function is available from software version 2.18 of Command. For thermostats with an older software version a
software update is necessary.
The Self Adaption determines the parameters by a test run of the thermostat. In this case the thermostat and, if
applicable, the external application must be ready for operation. ( 6).
The Self Adaption will be performed with the actually set pump step. Best results can be achieved with high pump
steps.
The test run must be performed at a passive system; this means that during the test run an exothermic or
endotherrmic reaction mustn't take place.
The test run takes depending on the external application about 30 minutes to 3 hours. The bath temperature will
oscillate in this time less than about ±15 Kelvin around the set temperature. After the test run the detected control
parameters will be taken over as control parameters automatically.
Command
Control Parameters
Control para. sets
Tv manual/auto
Self Adaption
Correction limitation
Pump Menu
03/2022
.
Settings
End T
set
Proline Kryomats
Set 3 and Upload actual
Self Adaption
 Open the device parameter menu via the
soft key
 With the cursor keys continue to:
Control

Parameters
 Confirm selection with
T
fix
, the new value is accepted into the
Menu .
Control

Self Adaption

.
Settings .

85 / 137