Voltage Regulator Heat Sink; Removing The Voltage-Regulator Heat Sink - Dell OptiPlex 7000 Small Form Factor Service Manual

Steps
1. Place the processor fan and heat-sink assembly on the system board and align the captive screws to the screw holes on the
system board.
2. Tighten the four captive screws that secure the heat stink to the system board.
3. Connect the processor-fan cable to the system board.
Next steps
1. Install the hard-drive and optical-drive
2. Install the front bezel.
3. Install the side cover.
4. Follow the procedure in

Voltage regulator heat sink

Removing the voltage-regulator heat sink

Prerequisites
1. Follow the procedure in
WARNING: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
54 Removing and installing components
bracket.
after working inside your
before working inside your
computer.
computer.