Voltage Regulator Heat Sink; Removing The Vr Heat Sinks - Dell D17S Service Manual

Steps
1. Insert the rubber grommets on the chassis.
2. Align the slots on the fan with the rubber grommets on the chassis.
3. Route the rubber grommets through the slots on the fan and pull the rubber grommets until the fan snaps into position.
4. Connect the fan cable to the connector on the system board.
Next steps
1. Install the front bezel.
2. Install the side cover.
3. Follow the procedure in

Voltage regulator heat sink

Removing the VR heat sinks

Prerequisites
1. Follow the procedure in
WARNING: The heat sink may become hot during normal operation. Allow sufficient time for the heat sink to
cool before you touch it.
CAUTION: For maximum cooling of the processor, do not touch the heat transfer areas on the heat sink. The
oils in your skin can reduce the heat transfer capability of the thermal grease.
2. Remove the side cover.
About this task
The following image indicates the location of the VR heat sink and provide a visual representation of the removal procedure.
after working inside your
before working inside your
computer.
computer.
Removing and installing components 63