Processor Fan And Heat-Sink Assembly; Removing The Processor Fan And Heat-Sink Assembly - Dell OptiPlex 7000 Small Form Factor Service Manual

About this task
The following images indicate the location of the memory and provide a visual representation of the installation procedure.
Steps
1. Ensure that the securing clips are in an open position.
2. Align the notch on the memory module with the tab on the memory-module slot.
3. Press down on the memory module until the memory module snaps into position and the securing clip locks in place.
CAUTION: To prevent damage to the memory module, hold the memory module by the edges. Do not touch
the components on the memory module.
NOTE: Repeat step 1 to step 3 when installing more than one memory module in your computer.
Next steps
1. Install the hard-drive and optical-drive
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the side cover.
5. Follow the procedure in

Processor fan and heat-sink assembly

Removing the processor fan and heat-sink assembly

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the hard-drive and optical-drive
About this task
The following images indicate the location of the processor fan and heat-sink assembly and provide a visual representation of
the removal procedure.
52 Removing and installing components
cage.
after working inside your
before working inside your
bracket.
computer.
computer.