Storage - Dell OptiPlex 7000 Small Form Factor Service Manual

Table 18. Integrated Devices (continued)
Options

Storage

This section provides storage details and settings.
Table 19. Storage
Options
SATA Operation
SATA Operation
Storage Interface
Port Enablement
SMART Reporting
Enable SMART Reporting
Drive Information
Enable MediaCard
Description
to clean or replace the dust filter based on the following time
intervals:
● Disabled (selected by default)
● 15 days
● 30 days
● 60 days
● 90 days
● 120 days
● 150 days
● 180 days
Description
This section allows the user to select the operating mode
of the integrated SATA hard drive controller. The following
options are available:
● Disabled - SATA controllers are disabled.
● AHCI - SATA is configured in AHCI mode.
● RAID On - SATA is setup to support RAID (Intel Rapid
Storage Technology). (Selected by default)
This section allows the user to enable or disable the onboard
drives on the computer. The following options is available (ON
by default).
● SATA-0
● SATA-1
● SATA-3
● M.2 PCIe SSD-0
● M.2 PCIe SSD-1
This section contains a toggle switch that allows the user
to enable or disable the S.M.A.R.T(Self-Monitoring, Analysis,
and Reporting Technology) option on the system (OFF by
default).
This section provides information about the connected and
active drives on the computer. The following options are
available:
● M.2 PCIe SSD-0
○ Type
○ Device
This section allows setting the media cards ON/OFF or
enable/disable media card in read-only state. The following
options are available:
BIOS setup 89