Hard-Drive And Optical-Drive Supporting Bracket; Removing The Hard-Drive And Optical-Drive Supporting Bracket - Dell OptiPlex 7000 Small Form Factor Service Manual

Steps
1. Align the notch on the 2290 solid-state drive with the tab on the M.2 card slot on the system board.
2. Slide the 2280 solid-state drive into the M.2 card slot on the system board.
3. Replace the screw (M2x3) that secures the 2280 solid-state drive to the system board.
Next steps
1. Install the hard-drive and optical-drive
2. Install the 3.5-inch hard-drive.
3. Install the 2.5-inch hard-drive.
4. Install the front bezel.
5. Install the side cover.
6. Follow the procedure in

Hard-drive and optical-drive supporting bracket

Removing the hard-drive and optical-drive supporting bracket

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch
5. Remove the 3.5-inch
36 Removing and installing components
bracket.
after working inside your
before working inside your
hard-drive.
hard-drive.
computer.
computer.