Table of Contents
Advertisement
About this task
The following images indicate the location of the power-supply unit and provide a visual representation of the removal
procedure.
Steps
1. Disconnect the power-supply cables from the connectors on the system board.
2. Remove the power-supply cables from the routing guides on the chassis.
3. Remove the three screws (M6-32) that secure the power-supply unit to the chassis.
4. Slide and lift the power-supply unit off the chassis.
Installing the power-supply unit
Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the power-supply unit and provides a visual representation of the installation
procedure.
70
Removing and installing components
- Quick Links:
- Hard Drive
Hide quick links:
Advertisement
Table of Contents
Need help?
Do you have a question about the OptiPlex 7000 Small Form Factor and is the answer not in the manual?
Questions and answers