Installing The Speaker; Power-Supply Unit; Removing The Power-Supply Unit - Dell OptiPlex 7000 Small Form Factor Service Manual

Installing the speaker

Prerequisites
If you are replacing a component, remove the existing component before performing the installation procedure.
About this task
The following image indicates the location of the speaker and provides a visual representation of the installation procedure.
Steps
1. Press and slide the speaker in the slot on the chassis until it snaps into place.
2. Route the speaker cable through the routing guide on the chassis.
3. Connect the speaker cable to the connector on the system board.
Next steps
1. Install the side cover.
2. Follow the procedure in

Power-supply unit

Removing the power-supply unit

Prerequisites
1. Follow the procedure in
2. Remove the side cover.
3. Remove the front bezel.
4. Remove the 2.5-inch
5. Remove the 3.5-inch
6. Remove the hard-drive and optical-drive
after working inside your
before working inside your
hard-drive.
hard-drive.
cage.
computer.
computer.
Removing and installing components 69