Table of Contents
Advertisement
Steps
1. Insert the rubber grommets on the chassis.
2. Align the slots on the fan with the rubber grommets on the chassis.
3. Route the rubber grommets through the slots on the fan and pull the rubber grommets until the fan snaps into position.
4. Connect the fan cable to the connector on the system board.
Next steps
1. Install the
side
cover.
2. Follow the procedure in
Voltage regulator heat sink
Removing the VR heat sink
Prerequisites
1. Follow the procedure in
after working inside your
before working inside your
computer.
computer.
Removing and installing components
55
Advertisement
Table of Contents
