LELY Calm View Installation & Operator's Manual page 7

Preface
Manual Contents
This manual contains the information for the correct installation, setup and maintenance of the Lely Calm
View. The information in this manual is for operators and technicians:
The operator uses the information to clean or replace the Lely Calm View.
•
The technician uses the information to install and set up the Lely Calm View.
•
Study and understand this information thoroughly before you install or do
maintenance the machine. Failure to do so could result in damage to equipment or
personal injury. Please consult your local Lely service provider if you do not
understand the information in this manual, or if you need additional information.
Store this manual in a safe place for future reference.
All information in this manual has been compiled with care. Lely shall not be liable for errors or faults in
this manual. The recommendations are meant to serve as guidelines. All instructions, pictures and
specifications in this manual are based on the latest information that was available at the time of
publication. Your machine may comprise improvements, features or options that are not covered in this
manual.
Applicability
Model designation
The table below shows the type numbers of concentrate feeder for which this manual is applicable.
Model
Lely Calm View
Software version
The description, operation and procedures in this manual are based on the following software versions:
XXXXXX Horizon or higher.
•
E-Link version 1.08R or higher.
•
• ADS3830 PCB; 01.09.0 or higher.
Standard Torque Loading of Parts
All the nuts, bolts and screws used on the machine are torque tightened to standard torque loadings
applicable to the construction materials used.
If a part has a non-standard torque loading, it is specified in the applicable part of the manual.
Registration
The Type and Serial Number Plate is attached to the top lid of the camera(2).
Preface
in n o vato rs in ag ric u ltu re
Type number
5.1701.0101.0
7