Table of Contents
Advertisement
SET-UP CONT'D
3. Insure that the foot pedal is attached to the
FOOT PEDAL Receptacle on the rear panel of
the power source.
4. Place foot pedal in a convenient position on the floor beneath the workstation.
5. Open the Model PE-210 SwaPlater Kit and study the enclosed operation manual if you are not
familiar with the system.
6. Remove the two power cords from the SwaPlater case.
7. Attach the Swatplater power cords to the PULSE PLATE Outputs. Connect the Black power
cord to the Black (-) receptacle and the Red power cord to the Red (+) receptacle.
8. Set the PULSE PLATE Output Control to the proper voltage for the plating task required. See
Swaplater Model PE-210 Operation and Maintenance Manual for complete details on plating
procedure.
94
Figure 121. Foot Pedal Connection
Advertisement
Table of Contents
