Table of Contents
Advertisement
TRADITIONAL METHOD CONT'D
4. Prepare a VisiFilter in the following manner.
a) Connect a 1 inch (2.5cm) length of clear pvc Air
Hose to each side of the VisiFilter; push and turn
hose onto VisiFilter nipple to seat.
b) To the free end of the Air Hose connected to the
FLOW IN side of the VisiFilter, insert the ridged end
of a female quick connect hose mount Fitting (P/N
1259-0086).
c) Insert the ridged end of a male quick connect hose
mount Fitting (P/N 1259-0087) in the free end of the
Air Hose connected to the FLOW OUT side of the VisiFilter.
d) Connect VisiFilter Air Hose (with attached male quick
connect hose mount Fitting) to the power source SNAP-VAC Port.
5. For vacuum, insert male quick connect hose mount Fitting connected to long Air Hose into
female Fitting on 1 inch (2.5cm) Air Hose (connected to VisiFilter). For pressure, insert male
quick connect hose mount fitting directly into the Controllable PRESSURE Port.
When removing any Air Hose, turn and pull. DO NOT attempt to pull hose
directly off. Damage to or breakage of Vacuum Fitting or VisiFilter may
occur.
6. Connect the handpiece power cord connector
plug to one of the Power Receptacles. For
convenience, PACE recommends the use of CH 3
for air handpieces.
34
Figure 20. VisiFilter Preparation
CAUTION
Figure 21. Handpiece Connection to TMC
Advertisement
Table of Contents
