Table of Contents
Advertisement
3. Attach one male quick connect hose Fitting
(with attached Air Hose) to the rear of the
Pik-Vac Handpiece.
4. Insert the other male quick connect hose
Fitting (with attached Air Hose) into the PIK-
VAC Port.
5. Attach the Metal Vacuum Tip to the end of
the Pik-Vac Handpiece.
OPERATION
1. Use of the Metal Vacuum Tip without a Vacuum Cup attached for removal/replacement of very
small component works well but for larger components, install one of the supplied Vacuum
Cups onto the tip. For best results, use a size slightly smaller than the body of the component
to be removed or placed. For very large components, use the largest Vacuum Cup.
2. Place the PIK-VAC Power Switch in the "ON" (1)
position to activate vacuum at the handpiece. The PIK-
VAC LED will illuminate whenever the swich is "ON".
3. Grasp the handpiece as you would a pen with the
Vacuum Cup (or tip) pointing down and the Vacuum
Control Port (refer to illustration on following page)
pointing up.
Figure 109. Pik-Vac Set-Up
Figure 110. Pik-Vac Power Switch
87
Advertisement
Table of Contents
