CHANGING THE PASSWORD CONT'D
3. Place Power Switch in the ON ("1") position. All
the THERMAL MANAGEMENT CENTER LEDs will
illuminate. The Digital Readout will read "888" and
change to read "1-0". This number may be different
on your unit.
4. Release the TIP SET and the °F/°C Keys. The
Digital Readout will now display "P - -" signifying that
the system has a Password installed. NOTE: If
"PS-" is displayed on the Digital Readout instead of
"P - -", a Password has not been previously
installed. Refer to the "INSTALLING A PASSWORD"
procedure.
5. Write down the new Password desired. Remember
that the TIP SET Key may never be the first key of a
password.
58
Figure 66. Digital Readout "888"
Figure 67. Digital Readout "P - -"
Figure 68. First Key Not Tip Set Key