Second Pump Add-On - Graco Wolverine A261 Series Instructions-Parts List Manual

Model and Component Identification
For ATEX DC (models CI-24X)
The pump assembly has terminals housed inside the
back cover plate of the motor. See F
1. Remove the rear cover plate of the motor.
2. Connect wires and related conduit (user-supplied)
rated per local electrical code. See F
diagrams, and Technical Specifications, on page
58, for current ratings.
MOTOR
F . 13 Electrical connections for Single Phase DC
IG
Pumps
3. Replace the motor junction box.
4. Connect a user-supplied ground wire to the ground
stud on the opposite side of the motor from the
motor wire exit.
22
. 5 on page 15.
IG
. 12 for wiring
IG
BLACK
LINE 1*
BLACK
LINE 2*

Second Pump Add-On

1. Follow Pressure Relief Procedure, page 23.
60
F . 14
IG
2. Remove the drive guard (60).
3. Remove the plug (107) on the side of the housing
(2) opposite of the existing pump.
4. Remove the two shoulder screws (17), and then
remove the plunger return block (16).
5. Follow Drive Section Repair (steps 8-11), page 33.
6. Replace drive guard (60).
2
17
16
107
334513N