Table of Contents
Advertisement
Quick Links
Instructions - Parts List
APEX
Oil Transfer Pump
For pumping non-flammable fluids including motor oils, hydraulic
fluid, and antifreeze. Do not use to pump water.
Model 260105, 3.0 gpm (11 lpm), 115 VAC (wall mount)
Model 260106, 3.0 gpm (11 lpm), 115 VAC
Model 260108, 4.2 gpm (16 lpm), 115 VAC
Model 260109, 7.9 gpm (30 lpm), 115 VAC
Model 260240, 6.3 gpm (24 lpm), 12 VDC (reversible)
150 psi (1.03 MPa, 10.3 bar) Maximum Working Pressure
Important Safety Instructions
Read all warnings and instructions in this
manual. Save these instructions.
Contents
Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2
Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4
Mounting Pump on Barrel or Tank . . . . . . . . . . . . . . . . 4
Mounting Pump In-line . . . . . . . . . . . . . . . . . . . . . . . . . 4
Electrical Installation . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Electrical Installation
12 VDC . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Operation . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5
Troubleshooting . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8
Technical Data . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 10
Dimensions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Performance Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . 12
Notes . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 13
Graco Standard Warranty . . . . . . . . . . . . . . . . . . . . . . . . 14
. . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14
Graco Inc. P.O. Box 1441 Minneapolis, MN 55440-1441
Copyright 2005, Graco Inc. is registered to I.S. EN ISO 9001
311306E
EN
Advertisement
Table of Contents
Related Manuals for Graco APEX 260106
Summary of Contents for Graco APEX 260106
-
Page 1: Table Of Contents
Notes ......... 13 Graco Standard Warranty ......14 Graco Information . -
Page 2: Warnings
Warnings Warnings The following general warnings are for the setup, use, grounding, maintenance, and repair of this equipment. Additional, more specific warnings may be found throughout the body of this manual where applicable. Symbols appearing in the body of the manual refer to these general warnings. When these symbols appear throughout the manual, refer back to these pages for a description of the specific hazard. - Page 3 Graco replacement parts only. • Do not alter or modify equipment. • Use equipment only for its intended purpose. Call your Graco distributor for informa- tion. • Route hoses and cables away from traffic areas, sharp edges, moving parts, and hot surfaces.
-
Page 4: Installation
Installation Installation 4. Apply pipe sealant to threads and install pipe into pump inlet. If you are pumping used oil, install suction These pumps are positive displacement gear tube assembly with inlet suction screen pumps. The models with AC motors are 115 (260306), to filter large contaminants. -
Page 5: Electrical Installation
Operation Electrical Installation Operation 115VAC The pump comes pre-wired with a 30 in. (762 Before servicing, turn pump off and open mm) power cord with a 3 prong grounded plug. the nozzle to relieve pressure. Power to the pump must be 115VAC, 60Hz, single phase. -
Page 6: Troubleshooting
Troubleshooting Troubleshooting Problem Cause Solution Motor runs but pump will not Dirt under pressure relief valve Remove pressure relief valve prime. or seal. and inspect, clean, or replace if damaged. Worn or damaged gears. Remove cover and inspect gears. Replace if worn or damaged. - Page 7 Troubleshooting Problem Cause Solution Unit pumps but output flow is Clogged inlet strainer (12). Clean or replace. low. Air leak in suction tube. Check to make sure all joints in suction tube are sealed. Suction tube too close to tank Suction tube must have a 2 in.
-
Page 8: Parts
Parts Parts Models 260105, 260106, 260108, 260109 Ref. No. Description Qty. Ref. No. Description Qty. SCREW, cap, 5/16-18 x 1 in. PUMP BODY, with swivel SCREW, cap, 5/16-18 x 1.5 in. PUMP BODY, without swivel (260105 only) PUMP BODY, SCREW, 3/8-16 x 1 in. high flow with swivel BRACKET, mounting (model ADAPTER, pump motor... - Page 9 Parts Kits Number Description Includes Items 260061 ADAPTER, bung 260245 KIT, fluid, 3 gpm with swivel 1a, 2, 3a, 4, 7, 8, 9, 10, 14, 15 (model 260106) 260246 KIT, fluid, 3 gpm without swivel 1b, 2, 3a, 4, 7, 8, 9, 10, 14, 15 (model 260105) 260247 KIT, fluid with swivel...
-
Page 10: Technical Data
Technical Data Technical Data Maximum working pressure 150 psi (1.05 MPa, 10.5 bar) Output flow Model 260105: 3.0 gpm (11 lpm) Model 260106: 3.0 gpm (11 lpm) Model 260108: 4.2 gpm (16 lpm) Model 260109: 7.9 gpm (30 lpm) Model 260240: 6.3 gpm (24 Ipm) Inlet size 1 in. -
Page 11: Dimensions
Technical Data Dimensions Length (A) Height (B) Width (C) Models Inches Inches Inches 260105 330.2 203.2 7.75 196.8 260106 330.2 203.2 7.75 196.8 260108 330.2 203.2 7.75 196.8 260109 330.2 203.2 6.25 158.7 260240 330.2 203.2 6.25 158.7 311306E... -
Page 12: Performance Chart
Technical Data Performance Chart 311306E... -
Page 13: Notes
Notes Notes 311306E... -
Page 14: Graco Standard Warranty
With the exception of any special, extended, or limited warranty published by Graco, Graco will, for a period of twelve months from the date of sale, repair or replace any part of the equipment determined by Graco to be defective.