检测模式 Detection Mode; 适用显示屏机型 Applicable To Display Models - Galanz XQG60-A708E After-Sales Service Manual

6.3 检测模式 Detection Mode
6.3.1 适用显示屏机型 Applicable to display models
将旋钮旋到 P01 位置，同时按住 K1+K2 键，然后插上电源进入检测模式。
Turn the knob to position P01, press and hold the K1+ K2 key at the same time, and then plug in the
power supply to enter the factory mode.
进入测试程序，蜂鸣发出"嘟嘟嘟、嘟嘟嘟"鸣叫，所有指示灯/ 图标闪烁 3 次，然后熄灭，显示屏剩余
时间显示"PLt"，锁门等待选择执行模式。此时若按启停键，程序执行自动检测模式；若旋动旋钮开关
则执行手动检测模式。具体流程如下：
Enter the test program, the buzzer will sound, all indicator lights/icons will flash for 3 times, and then
turn off, the display screen will display "PLt" for the remaining time, lock the door and wait to select
the execution mode. At this time, if you press the "Start/Pause" key, the program will execute the
automatic detection mode; if you turn the knob switch, the manual detection mode will be executed.
The specific process is as follows:
设定 Set up
C01 预洗阀测试
（P02 位置）
C01 pre washing
valve test
(P02 position)
C02 主洗阀测试
（P03 位置）
C02 main
washing valve
test
(P03 position)
C03 软化阀测试
（P04 位置）
C03 softening
valve test
(P04 position)
C05 加热测试
（P06 位置）
C05 heating test
(P06 position)
C06 电机转动方向
测试（P07 位置）
C06 motor
rotation direction
注水设定时间
Water injection setting time.
注水设定时间
Water injection setting time.
注水设定时间
Water injection setting time.
判断水位是否已在加热水位以上，如未到必须先补水至加热水位，然后启动加
热，加热设定时间 Judge whether the water level is above the heating water
level, if not, make up water to the heating water level first, then start the
heating, set the heating time.
正转设定时间
Forward rotation setting time.
描述 Describe
XYJGT6070AQFDE-001
25