Galanz XQG60-A708E After-Sales Service Manual page 51

拆除减震器销（箱体）
Remove absorber pin (Cabinet)
XYJGT6070AQFDE-001
1.用 13 号外六角套
筒配合电批拆除左图
上配重块螺钉 1、2、
3
Remove the upper
balancer screws 1, 2
and 3 with No.13
outer hexagon
sleeve and electric
driver.
2.拆出的配重块要轻
拿轻放，避免损坏
The removed
balancer should be
handled with care to
avoid damage.
3.拔出水位开关接线
端子 4、5、6， 把水
位开关旋转 90 度，
拆下水位开关
Pull out the four
sockets 4, 5 and 6 of
the water level
switch, turn the
pressure switch 90
degrees and
remove the Water
level switch.
注意水位开关的线
组顺序：4 是两条蓝
色，5 是一条粗和一
条细的蓝色或黑色，
6 是单条白色，重装
时注意不要接错，否
则可能引起报警
Pay attention to the
line group
sequence of
pressure switch: 4
two blue line, 5 one
thick and one thin
blue or black line, 6
single white line.
Pay attention not to
connect the wrong
line when
reassembling,
otherwise it may
cause alarm.
50