Table of Contents
Advertisement
XYJGT6070UDE-002
The software version detection displays the version information of the current software (i.e. prg
version) and the product information stored in the nonvolatile memory (i.e. customer product number,
3 digits in total).
1)按"启动/暂停"键，显示屏显示"t02" ；按 K4 键，显示屏显示"t03" ，按"启动/暂停"键进入测试
程序，显示屏显示"Sct"
Press the "Start/Pause" key, the display screen displays "t02"; Press the K4 key, the display screen
displays "t03", press the "Start/Pause" key to enter the test program, the display screen displays "Sct"
2)按"启动/暂停"键，显示屏显示"cod" ，再切换到显示三位的软件大版本信息（即：prg version） ，
然后显示测试版本号（小版本号信息） ，如此循环交替显示
Press the "Start/ Pause" button, the display screen displays "cod", then switch to display the large
version information of the software in three digits (i.e., prg version), and then display the test version
number (small version number information), and the display cycle alternately.
3)在正式产品阶段软件版本信息显示从"000"开始递增
In the formal product stage, the software version information is displayed from "000".
4)再按 K4 键，显示屏显示"PC"再切换到显示三位的产品号，如此循环交替显示
Press K4 again, the display screen will display "PC" and then switch to the display of three-digit
product number, and the display will be displayed alternately in this cycle.
6.3 检测模式 Detection Mode
上电 30 秒内，选择 P01 程序，同时按 K1 及 K4 键 3 秒不放,进入测试程序，蜂鸣发出"嘟嘟嘟、嘟嘟
嘟"鸣叫，所有指示灯、图标闪烁 3 次，然后熄灭，显示屏剩余时间显示"PLt",锁门等待选择执行
模式。此时若按"启动/暂停"键，程序执行自动检测模式；若选择 K4、K5 则执行手动检测模式。具
体流程如下：
Within 30 seconds of power on, select the P01 program, press the K1 and K4 keys for 3 seconds at
the same time to enter the test program, the buzzer will sound, all indicator lights/icons will flash three
times, and then go out, the remaining time of the display will display "PLt", lock the door and wait for
the execution mode to be selected. At this time, if you press the "Start/Pause" button, the program will
execute the automatic detection mode; if you press the K4, K5 key, the program will execute the
manual detection mode. The specific process is as follows:
19
Advertisement
Table of Contents
