Galanz XQG60-A708E After-Sales Service Manual page 55

1.拔出滤波器上的四
个接线端子 1、2、3、
4 和接地端子 5
Pull out the four
terminals 1, 2, 3, 4
and grounding
terminal 5 on the
filter.
2.用十字批拆除背面
的两个螺钉 6、7
Remove the two
screws 6 and 7 on
the back with a
cross screwdriver.
3.取出滤波器
Remove the filter.
4.用平口钳夹紧电源
线位置 8 后旋转 90
度后拉出电源线
Clamp position 8 of
the power cord with
a pair of flat tongs
and pull out the
power cord after
rotating 90 degrees.
拆除发热管组件
Remove the heater
XYJGT6070AQFDE-001
1.滤波器上的 1、2、
3、 4 位置线组顺序不
能乱：1 单条电源线
蓝色，2 单条粗的蓝
色，3 一条粗和一条
细的棕色，4 单条电
源线棕色，否则可能
引起报警
The sequence of
line groups of
position 1, 2, 3 and
4 on the filter: 1
single power line is
blue, 2 one thick
and one thin blue, 3
one thick and one
thin brown, 4 single
power line is brown,
which cannot be
connected wrong,
otherwise it may
cause alarm.
2.拆出的滤波器和电
源线做好防护
Protect the
removed filter and
power cord.
54