适用非显示屏机型 Applicable To Non-Display Models - Galanz XQG60-A708E After-Sales Service Manual

The test can be carried out in different stages;
⇒ 在此模式下，若旋钮不在以上测试位置，则无任何响应；
If the knob is not in the above test position in this mode, there is no response;
◆退出此模式关闭电源旋钮。
◆Exit this mode and turn off the power knob.
6.3.2 适用非显示屏机型 Applicable to non-display models
1） 通电前按住 K1+K2 键不放，通电后直到听到蜂鸣器发出"嘀、嘀、嘀"三声，提示已经进入特殊
选择模式。界面显示：程序选择旋钮指示灯显示当前程序旋钮的位置，同时"启动/暂停"指示灯以 1Hz
的频率闪烁。
Hold the K1+K2 button before power on, until the buzzer "di, di, di" is heard, indicating that the special
selection mode has been entered. Interface display: the program selection knob indicator shows the
current position of the program knob, while the "start/stop" indicator flashes at the frequency of 1Hz.
2） 将程序旋钮转至 P7 位置，按下启动/暂停键，程序进入检测模式。所有 LED 指示灯闪烁 3 秒，开
始自动执行检测。
Turn the knob to P7, press the start/ pause button, the program enters detection mode. All LED
indicator lights flash for 3 seconds, and the following detection starts automatically.
3） 将程序旋钮转至 P8 位置，按下启动/暂停键，程序进入检测模式。所有 LED 指示灯闪烁 3 秒，然
后，再次按下启动/暂停键，开始单步执行当前旋钮位置所对应的检测。
Turn the knob to P8, press the start/ pause button, the program enters detection mode. All LED lights
flash for 3 seconds, then press the Start/Pause button again to step through the detection
corresponding to the current knob position.
检测流程如下：
The testing process is as follows:
设定 Set up
预洗阀测试
（P8 位置）
Pre washing valve
test
(P8 position)
主洗阀测试
（P7 位置）
Main washing
注水设定时间
Water injection setting time.
注水设定时间
Water injection setting time.
描述 Describe
XYJGT6070AQFDE-001
27