Galanz XQG60-A708E After-Sales Service Manual page 22

Turn the knob to position P02, press and hold the K1+K2 keys, then insert the power supply, the
display screen will display "P2", press the Start/Pause key, the display screen will display "t2", then
enter the service mode; turn the knob to enter the corresponding test program.
程序进入服务模式时，自动锁门排空筒内积水。在排水过程中，屏蔽所有按键动作并且童锁指示灯以
1Hz 的频率闪烁。当水排空后，童锁自动解除，所有按键恢复有效，并显示当前测试步骤 t01～t08。
不同测试程序之间通过程序选择旋钮切换。
When the program enters the service mode, the door is automatically locked to empty the water in the
cylinder. During the drainage process, all key actions are shielded and the child lock indicator light
flashes at the frequency of 1Hz.When the water is drained, the child lock will be released
automatically, all buttons will be valid, and the current test steps t01～t08 will be displayed. The
program selection knob is used to switch between different test programs.
D-LED/LCD Model：
旋钮位置
Position knob
P01
P02
P07
P08
旋钮选择测试程序， 按第一次启动暂停键确定选择， 按第二次启动暂停键启动执行当前选定的测试程序，
按第三次启动暂停键取消当前正在执行的测试程序， 排空筒内积水并且返回到选择测试程序状态。 在测
试程序运行过程中，如果旋动程序选择旋钮，程序将排空筒内积水并且返回到测试程序选择模式。在测
试模式下， 屏蔽所有错误报警和软件安全保护功能模块， 以方便测试程序检测相应功能模块的工作情况。
The knob selects the test program. Press the first "Start/Pause" key to confirm the selection, press
the second "Start/Pause" key to start the currently selected test program, press the third "Start/Pause"
key to cancel the currently executing test program, drain the water in the cylinder and return to the
selected test program state. During the running of the test program, if you turn the program selection
knob, the program will drain the water in the cylinder and return to the test program selection mode. In
the test mode, all error alarms and software security protection function modules are shielded to
...
XYJGT6070AQFDE-001
测试代码显示
Test code display
t01
t02
...
t07
t08
21