Galanz XQG60-A708E After-Sales Service Manual page 43

拆除前上加强板
Remove the upper frame
XYJGT6070AQFDE-001
4.用剪钳剪去图中所
示两段扎带 1、2
Use diagonal cutters
to cut out tie 1 and 2
as shown in the
figure.
5.拔出电脑板上的接
线端子 3、4、5、6、
7、8
Pull out all wiring
harness terminals 3,
4, 5, 6, 7 and 8 on
the PCB.
6.取出面板组件后做
好防静电和防刮花保
护
After the control
panel as is
removed, do a good
job of anti-static and
anti scratch
protection.
1.使用剪钳时注意不
要剪断线组
Pay attention not to
cut the thread group
when using the
diagonal cutters.
2.注意拔出接线端子
时请戴防静电手套
Please wear
antistatic gloves
when pulling out the
terminal.
3.装机时需另外补充
两条扎带
Additional ties
should be added
when reinstalling
the machine.
42