Galanz XQG60-A708E After-Sales Service Manual page 29

valve test
(P7 position)
软化阀测试
（P6 位置）
Softening valve
test
(P6 position)
热水阀测试
（P5 位置）
Hot water valve
test
(P5 position)
加热测试
（P4 位置）
Heating test
(P4 position)
电机转动方向测试
（P3 位置）
Motor rotation
direction test
(P3 position)
外筒泄漏测试
（P2 位置）
Outer cylinder
leakage test
(P2 position)
排脱水测试
（P1 位置）
Dewatering test
(P1 position)
注：Note:
◆测试过程中，检测故障报警，如在当前阶段发生时，立即报警，并停止执行程序。
During the testing process, detect the fault alarm, such as in the current stage, immediately alarm,
and stop the execution of the program.
◆关闭电源退出此模式。
Power off to exit this mode.
注水设定时间
Water injection setting time.
注水设定时间
Water injection setting time.
判断水位是否已在加热水位以上，如未到必须先补水至加热水位，然后启动加
热，加热设定时间（功率表读取加热功率）
Judge whether the water level is above the heating water level, if not, make
up water to the heating water level first, then start the heating, set the heating
time (the power meter reads the heating power).
正转设定时间
Forward rotation setting time.
判断水位是否已在洗涤 1 水位，如未到必须先补水至洗涤 1 水位，反转设定时
间
Judge whether the water level is at the level of washing 1, if not, make up
water to the level of washing 1, and reverse the set time.
先排水至空筒 0 水位以下，然后以最高速脱水（无须不平衡检测） ，加速及高速
过程持续设定时间，关闭电机输出。
First drain water to the level below 0 of the empty cylinder, then dehydrate at
the highest speed (without imbalance detection), and the motor output will be
turned off when the acceleration and high-speed process lasts for a set time.
XYJGT6070AQFDE-001
28