Section 7: Programming; Ul 864 Programming Requirements; Modules; 1: Edit Modules - Honeywell Gamewell-FCI GWF-7075 Installation And Operation Manual

Addressable fire alarm control panel

Table of Contents

To manually program the control panel from the built-in annunciator. Each subsection discusses these menu options in detail. All

options described in this section can be performed using the HFSS Honeywell Fire Software Suite.

Before you complete any customized programming, you must first run JumpStart

oughly test the system. The reason you test the system after JumpStart Auto-programming is to activate JumpStart Auto-programming

to automatically program the system, searching for and configuring all SLC and SBUS devices it finds. JumpStart allows you to con-

firm the integrity of the installation prior to performing any custom programming. After you determine the hardware is properly

installed, you can perform custom programming.

7.1 UL 864 Programming Requirements

NOTICE TO USERS, INSTALLERS, AUTHORITIES HAVING JURISDICTION, AND OTHER INVOLVED PARTIES: This product

incorporates field programmable software. In order for the product to comply with the requirements in the Standard for Control Units and

Accessories for Fire Alarm Systems, UL 864, certain programming features or options must be limited to specific values or not used at all

as indicated below.

Programming Option

Time Options

Display Oldest Event

Alarm Verification

7.2 Modules

This section lists the options available under the Module Option in the Program Menu. The types of modules available for the control

panel are as follows:

• RA-1000 LCD Annunciator • 5824 Serial/Parallel input/output • 5880 LED Input/Output module • GFPS-6S NAC Expander

7.2.1 Edit Modules

If you select Edit Modules, you can edit the module name and class of wiring (Class A or Class B) features. To edit an existing module,

follow these steps:

Enter the Installer Code.

Select 7 for Program Menu.

Press 1 to enter Module menu.

Press 1 to edit a module.

Use the <Up> or <Down> arrows to select the module you want to edit.

7.2.2 Editing Module ID

Press the <Up> or <Down> arrows key to modify the Module ID.

NOTE: You cannot edit the Module ID on Internal devices.

7.2.3 Naming Modules

You can assign an English name to a hardware module to make it easier to recognize on a display.

To edit a Module Name, press the <Up> or <Down> arrows to select each character for the module's name (or press the <Right>

arrow to bypass the name edit). Press the <Right> arrow to move the cursor to the next character.

NOTE: To edit names, refer Appendix Appendix A:.