GE LOGIQ A100 Technical Publication page 291

Key to Tables (cont'd)
Parameter
Maximum Power
I
ob
Power-up Mode
Initialization Mode
Acoustic Output
Freeze
I
tt
I
ts
Table 34
t
α 100 User Manual
LOGIQ
2211157–100 Rev 0
Unit
mW Maximum temporal-average power output. For
scanning modes, this shall be the total power
output of all the acoustic pulses.
2
mW/cm Output beam intensity.
In systems in which the user defines the
power-up mode, this shall be stated as either
"user defined" or "not applicable" (n/a).
In systems in which the user defines the
initialization mode, this shall be stated as either
"user defined" or "not applicable" (n/a).
If the system has acoustic output freeze, then
this shall be stated as "yes;" otherwise, it shall be
stated as "no."
mm Transducer to transducer-output-face distance.
mm Typical value for the transducer stand-off
distance. If the transducer assembly is normally
used in contact with the patient, then this shall be
specified "contact" system.
. Key to IEC Table Value (cont'd)
Probes
Description
275