GE LOGIQ A100 Technical Publication page 107

Connecting Probes to the Two Probe Port (cont'd)
The LED toggles to indicate the probe change.
LED
 Â
 Â
.
A click is also heard to indicate the switch over.
audible click
NOTE: Inadvertent pressing of the switch key
only one probe is connected causes the system to toggle
ports and any captured image will be lost.
t
α 100 User Manual
LOGIQ
2211157–100 Rev 0
5. Align the connector with either of the ports and
carefully push in place.
6. Turn the probe connector lock in the clockwise
direction through one quadrant. The connector is
now secured to the two probe port.
7. Carefully position the probe cord such that it is
not put to undue stress.
8. Press the Switch key on the Two Probe Port to
switch to the connected port.
Two Probe Port
when
91