Dpi Header (P3); Dai Header (P4); Jtag Header (Zp4) - Analog Devices ADSP-21369 EZ-KIT Lite Manual

DPI Header (P3)

The DPI connector (
from of a .1" spacing header. When using the header to access the DPI
pins of the processor, ensure that signals, which normally drive the DPI
pins, are disabled. For more information, see
Part Description
20-pin IDC header

DAI Header (P4)

The DAI connector (
from of a .1" spacing header. When using the header to access the DAI
pins of the processor, ensure that signals, which normally drive the DAI
pins, are disabled. Refer to
more information on how to disable signals already being driven from
elsewhere on the EZ-KIT Lite.
Part Description
26-pin IDC header

JTAG Header (ZP4)

The JTAG header (
emulator pod. When an emulator connects to the JTAG header, the USB
debug interface is disabled.

Pin 3 is missing to provide keying. Pin 3 in the mating connector
should have a plug.
ADSP-21369 EZ-KIT Lite Evaluation System Manual
ADSP-21369 EZ-KIT Lite Hardware Reference
) provides access to all of the DPI signals in the
P3
Manufacturer
FCI
) provides access to all of the DAI signals in the
P4
"Codec Setup Switch (SW3)" on page 2-11
Manufacturer
BERG
) is the connecting point for a JTAG in-circuit
ZP4
"DPI Interface" on page
Part Number
68737-420HLF
Part Number
4102-T08-13LF
2-5.
for
2-25