Analog Devices ADSP-21369 EZ-KIT Lite Manual page 25

Using an Emulator:
1. Plug one side of the USB cable into the USB connector of the emu-
lator. Plug the other side into a USB port of the PC running
CCES.
2. Attach the emulator to the header connector
the EZ-KIT Lite board.
Using the on-board Debug Agent:
1. Plug one side of the USB cable into the USB connector of the
debug agent
2. Plug the other side of the cable into a USB port of the PC running
CCES.
Step 2: Attach the provided cord and appropriate plug to the 5V power
adaptor.
1. Plug the jack-end of the power adaptor into the power connector
(labeled
J4
2. Plug the other side of the power adaptor into a power outlet. The
power LED (labeled
board.
3. Power the emulator (if used). Plug the jack-end of the assembled
power adaptor into the emulator and plug the other side of the
power adaptor into a power outlet. The enable/power indicator is
lit green when power is applied.
Step 3 (if connected through the debug agent): Verify that the yellow
USB monitor LED (labeled
) on the debug agent are both on. This signifies that the board is
ZLED4
communicating properly with the host PC and ready to run CCES.
ADSP-21369 EZ-KIT Lite Evaluation System Manual
Using the ADSP-21369 EZ-KIT Lite
(labeled ).
ZP1 USB
) on the EZ-KIT Lite board.
7.5V
) is lit green when power is applied to the
LED9
)and the green power LED (labeled
ZLED3
(labeled ) on
ZP4 JTAG
1-5