Disassembly/Assembly Of Covers; Removing The Engine Cover; Fitting New Screw Mounts To The Engine Cover - Stiga PARK 120 2016 Workshop Manual

Edition Workshop Manual
2016 PARK 120 - PARK 220
2.1

Disassembly/assembly of covers

2.1.1

Removing the engine cover

B
2.1.2

Fitting new screw mounts to the engine cover

New screw mounts can be mounted on the rear frame if the previous screw mounts are
faulty.
A
C
D
A (4x)
C
1. Unscrew the four screws (A) holding the cover,
use torx T30.
2. Open the cover.
3. Take the cap off the petrol tank.
4. Reclose the cover.
5. Remove the cover.
6. Replace the cap on the petrol tank.
To reassemble the various parts, repeat the
operations in reverse order.
Remove the faulty screw mount as follows:
1. Use a 8.5 mm drill. Drill down to the thread
from the outside.
B
2. Pull out the screw mount from the inside with
pliers.
Install new as follows:
1. Install the rivet (A) from the outside, with the
flange outward.
2. Assemble screw (B) is screwed through the
rivet, from within.
3. Put on the washer (C) and the nut (D), from
the outside.
4. Hold the screw and tighten the nut so the rivet
expands and locks into the rear frame. The
rivet should not rotate!
5. Remove the assembly screw and mount cover
with regular screws.
Chapter
2 Frame and Covers
Page
16