Assembly; Adjustment - Stiga PARK 120 2016 Workshop Manual

Edition Workshop Manual
2016 PARK 120 - PARK 220
6.4.2

Assembly

1. Pour some oil drops on the two cable terminals and move the wire a few times inside its
sheath.
2. Follow the instructions in reverse order to reassemble.
3. Install new cable ties.
4. Adjusting the cable
6.4.3

Adjustment

NEVER use a machine with faulty brakes!
Check that the cables are slack when the parking brake is not engaged.
Incorrect adjustment will result in greater wear on the brakes.
Adjust the cable on the front and rear registers to achieve minimum play.
Then check that the parking brake works correctly.
Perform further adjustment if necessary.
6.4.3
Danger!
Caution!
Chapter
6 Control cables
Page
48