Replacing The Link Arm - Stiga PARK 120 2016 Workshop Manual

Edition Workshop Manual
2016 PARK 120 - PARK 220
2.2

Replacing the link arm

Remove the link arm, as follows:
Support the machine safely, on the rear side of the frame and on the front frame
near the arm, to ensure it does not roll over. Keep it lifted using a jack or wooden
planks.
Warning!
1. Unscrew the bolt (A-17 mm wrench.
2. Unscrew the bolt (B-17 mm wrench).
3. Replace the link arm and then mount it together
in reverse order.
4. If it is difficult to fit bolt (A) during assembly, lift
up the front frame for an easier mounting of
the bolt.
B
A
Chapter
2 Frame and Covers
Page
21